FRONT PASSENGER AIRBAG ASSEMBLY (for TMC, TMMR Made) > REMOVAL |
| 1. PRECAUTION |
| 2. REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY |
| 3. DISCONNECT NO. 2 INSTRUMENT PANEL WIRE |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Slide the slider to release the lock, and then disconnect the connector.
| *a | Slider |
| 4. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY |
Disconnect each connector.

| *A | w/ Ion Generator | - | - |
Disengage each clamp.
![]() |
Disconnect the glove box light as shown in the illustration.
Remove the 2 passenger airbag bolts <A>.

| *1 | Passenger Airbag Bolt <A> | *2 | Bolt <B> |
| *3 | Nut <F> or <G> | *4 | Clip |
Remove the 3 bolts <B> and nut <F> or <G>.
Remove the 2 clips.
Disengage the 5 guides and remove the instrument panel safety pad assembly as shown in the illustration.

| 5. REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY |
![]() |
Remove the 2 screws.
![]() |
Lean the instrument panel safety pad assembly and disengage the 3 hooks.
![]() |
Disengage the 3 hooks to remove the instrument panel passenger airbag assembly from the instrument panel safety pad assembly.
| 6. REMOVE NO. 2 INSTRUMENT PANEL WIRE |
![]() |
Disengage the clamp.
Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock.
| *1 | Protective Tape |
| *2 | Airbag Connector |
| *3 | Airbag Connector Lock |
Disconnect the airbag connector to remove the No. 2 instrument panel wire from the instrument panel passenger airbag assembly.