Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CURTAIN SHIELD AIRBAG ASSEMBLY (for TMMK Made)

CURTAIN SHIELD AIRBAG ASSEMBLY (for TMMK Made) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. INSTALL REAR NO. 2 SIDE RAIL SPACER
  1. Engage the 2 clips to install a new rear No. 2 side rail spacer.



2. INSTALL REAR NO. 3 SIDE RAIL SPACER


    B369952
  1. Insert the guide into the body hole and engage the clip to temporarily install a new rear No. 3 side rail spacer.

  1. Install a new bolt.

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }



3. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY

NOTICE:
When installing the curtain shield airbag assembly, have assistants hold it to prevent it from bending.

  1. Check that the engine switch is off.

  1. Check that the cable is disconnected from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



  1. Insert the 2 guides and 2 hooks into each body hole, install 3 new bolts, 5 new clips (A) with pins and 2 spacers, and engage 4 clips (B) in the order shown in the illustration to install the curtain shield airbag assembly.

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }

    NOTICE:
    1. If the curtain shield airbag assembly has been dropped, replace it with a new one.
    2. Do not twist the curtain shield airbag assembly when installing it.

    HINT:
    Engage the 2 claws to install each new clip (A).



    B417712E01


    Text in Illustration 
    *1
    Pin
    *2
    Spacer
    *a
    Clip (A)
    *b
    Spacer Location
    *c
    Guide
    *d
    Hook

  1. Using needle nose pliers, push the 5 pins into the 5 clips (A).

    NOTICE:
    1. Do not damage the pins.
    2. Make sure that the pins of the clips (A) are pushed in firmly.



    B369948E01
  1. Connect the airbag connector.
    Text in Illustration 
    *a
    Airbag Connector
    *b
    Airbag Connector Lock

    NOTICE:
    When connecting any airbag connector, take care not to damage the airbag wire harness.

  1. Push in the airbag connector lock to install the airbag connector.



4. INSTALL ROOF HEADLINING ASSEMBLY
(Click here)


5. PERFORM DIAGNOSTIC SYSTEM CHECK
(Click here)