Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM

TOYOTA PARKING ASSIST-SENSOR SYSTEM > OPERATION CHECK

for Preparation Click here



MALFUNCTION DISPLAY (MULTI-INFORMATION DISPLAY)


  1. Open circuit indication



    1. If there is an open circuit between a No. 1 ultrasonic sensor and the clearance warning ECU assembly or a sensor is malfunctioning, the malfunction is displayed as shown in the illustration.


      E303255E01

      HINT:
      If a sensor has an open circuit, check for DTCs and troubleshoot according to each inspection procedure (Click here).



  2. Frozen indication



    1. If a sensor is covered with foreign matter, such as mud or snow, the affected sensor is displayed as shown in the illustration.


      E303950E01

      HINT:
      1. If a frozen indication is displayed, read Precaution for Toyota Parking Assist-sensor System first and confirm that the sensor is not covered with foreign matter (Click here).
      2. Check for DTCs and troubleshoot according to each inspection procedure after confirming that the sensor is not covered with foreign matter (Click here).


MALFUNCTION DISPLAY (MULTI-DISPLAY (w/ Parking Assist Monitor System))


  1. Open circuit indication



    1. If there is an open circuit between a No. 1 ultrasonic sensor and the clearance warning ECU assembly or a sensor is malfunctioning, the malfunction is displayed as shown in the illustration.


      E302156E01


      Text in Illustration 
      *a
      When the shift lever is in R
      -
      -

      HINT:
      If a sensor has an open circuit, check for DTCs and troubleshoot according to each inspection procedure (Click here).



  2. Frozen indication



    1. If a sensor is covered with foreign matter, such as mud or snow, the affected sensor is displayed as shown in the illustration.


      E302157E01


      Text in Illustration 
      *a
      When the shift lever is in R
      -
      -

      HINT:
      1. If a frozen indication is displayed, read Precaution for Toyota Parking Assist-sensor System first and confirm that the sensor is not covered with foreign matter (Click here).
      2. Check for DTCs and troubleshoot according to each inspection procedure after confirming that the sensor is not covered with foreign matter (Click here).


DETECTION RANGE MEASUREMENT AND DISPLAY INSPECTION

NOTICE:
The following measurement and inspection will be performed with the shift lever in a position other than P. Be sure to apply the parking lever and depress the brake pedal firmly to prevent the vehicle from moving.

  1. Turn the ignition switch to ON.

  2. Turn the clearance sonar main switch on.



  3. Detection range measurement:

    1. Move the shift lever according to the table below.

      Measurement Area
      Shift Lever Position
      Front Corner
      In any position other than P
      Rear Corner
      R
      Rear Center



    2. Move a 60 mm (2.36 in.) diameter pole near each sensor to measure its detection range. When measuring the longest-range detection of the front center sonar and the rear center sonar, use a wall or equivalent.

      NOTICE:
      These detection ranges are applicable when positioning the 60 mm (2.36 in.) diameter pole parallel or perpendicular to the ground. The detection range varies depending on the measuring method and type of obstacle (such as walls).

      HINT:
      Have an assistant move the pole.


      E303951E01

      NOTICE:
      The No. 1 ultrasonic sensor side view detection range (hatched area labeled (B)) represents the cross section of the top view detection range (A). The hatched area (B) does not represent the entire side view detection range.


      E303952E01



  4. Front corner sonar display and buzzer operation check



    1. When the No. 1 ultrasonic sensors (front corner sonar) have detected an obstacle, check the displays and check that the buzzer sounds.

      Operation Condition 
      Ignition Switch
      Clearance Sonar Main Switch
      Shift Lever Position
      Vehicle Speed
      ON
      On
      In any position other than P or R
      1. Less than approximately 13 km/h (8.1 mph) if speed is increasing
      2. Less than approximately 9 km/h (5.6 mph) if speed is decreasing
      ON
      On
      R
      -


      E303953E01


      Text in Illustration 
      *a
      Multi-information Display
      *b
      Multi-display (w/ Parking Assist Monitor System)
      *c
      Close-range Detection
      *d
      Medium-range Detection
      *e
      Long-range Detection
      *f
      When the shift lever is in R

      E124674E20


      Standard:

      Multi-information Display and Buzzer 
      Detection Range
      During Judgment
      Obstacle
      Close-range detection
      Within approx. 300 +/- 30 mm (11.8 +/- 1.18 in.)
      Buzzer: Sounds continuously
      Number of bars displayed: 1 (blinking)
      60 mm (2.36 in.) diameter pole
      Medium-range detection
      From approx. 300 +/- 30 to 400 +/- 40 mm (11.8 +/- 1.18 to 15.7 +/- 1.57 in.)
      Buzzer: Sounds intermittently (ON: 0.075 sec. / OFF: 0.075 sec.)
      Number of bars displayed: 2 (illuminated)
      60 mm (2.36 in.) diameter pole
      Long-range detection
      From approx. 400 +/- 40 to 500 +/- 50 mm (15.7 +/- 1.57 to 19.7 +/- 1.97 in.)
      Buzzer: Sounds intermittently (ON: 0.15 sec. / OFF: 0.15 sec.)
      Number of bars displayed: 3 (illuminated)
      60 mm (2.36 in.) diameter pole

      HINT:
      Ultrasonic waves are used to measure the detection range; however, the detection range may vary depending on the ambient temperature.



  5. Rear corner sonar display and buzzer operation check



    1. When the No. 1 ultrasonic sensors (rear corner sonar) have detected an obstacle, check the display and check that the buzzer sounds.

      Operation Condition 
      Ignition Switch
      Clearance Sonar Main Switch
      Shift Lever Position
      Vehicle Speed
      ON
      On
      R
      -


      E303954E01


      Text in Illustration 
      *a
      Multi-information Display
      *b
      Multi-display (w/ Parking Assist Monitor System)
      *c
      Close-range Detection
      *d
      Medium-range Detection
      *e
      Long-range Detection
      -
      -

      E124674E21


      Standard:

      Multi-information Display and Buzzer 
      Detection Range
      During Judgment
      Obstacle
      Close-range detection
      Within approx. 300 +/- 30 mm (11.8 +/- 1.18 in.)
      Buzzer: Sounds continuously
      Number of bars displayed: 1 (blinking)
      60 mm (2.36 in.) diameter pole
      Medium-range detection
      From approx. 300 +/- 30 to 450 +/- 50 mm (11.8 +/- 1.18 to 17.7 +/- 1.97 in.)
      Buzzer: Sounds intermittently (ON: 0.075 sec. / OFF: 0.075 sec.)
      Number of bars displayed: 2 (illuminated)
      60 mm (2.36 in.) diameter pole
      Long-range detection
      From approx. 450 +/- 50 to 600 +/- 60 mm (17.7 +/- 1.97 to 23.6 +/- 2.36 in.)
      Buzzer: Sounds intermittently (ON: 0.15 sec. / OFF: 0.15 sec.)
      Number of bars displayed: 3 (illuminated)
      60 mm (2.36 in.) diameter pole

      HINT:
      Ultrasonic waves are used to measure the detection range; however, the detection range may vary depending on the ambient temperature.



  6. Rear center sonar display and buzzer operation check



    1. When the No. 1 ultrasonic sensors (rear center sonar) have detected an obstacle, check the display and check that the buzzer sounds.

      Operation Condition 
      Ignition Switch
      Clearance Sonar Main Switch
      Shift Lever Position
      Vehicle Speed
      ON
      On
      R
      -


      E303955E01


      Text in Illustration 
      *a
      Multi-information Display
      *b
      Multi-display (w/ Parking Assist Monitor System)
      *c
      Close-range Detection
      *d
      Medium-range Detection
      *e
      Long-range Detection
      *f
      Longest-range Detection

      E235234E05


      Standard:

      Multi-information Display and Buzzer 
      Detection Range
      During Detection
      Obstacle
      Close-range detection
      Within approx. 350 +/- 40 mm (13.8 +/- 1.57 in.)
      Buzzer: Sounds continuously
      Number of bars displayed: 1 (blinking)
      60 mm (2.36 in.) diameter pole
      Medium-range detection
      From approx. 350 +/- 40 to 450 +/- 50 mm (13.8 +/- 1.57 to 17.7 +/- 1.97 in.)
      Buzzer: Sounds intermittently (ON: 0.075 sec. / OFF: 0.075 sec.)
      Number of bars displayed: 2 (illuminated)
      60 mm (2.36 in.) diameter pole
      Long-range detection
      From approx. 450 +/- 50 to 600 +/- 60 mm (17.7 +/- 1.97 to 23.6 +/- 2.36 in.)
      Buzzer: Sounds intermittently (ON: 0.15 sec. / OFF: 0.15 sec.)
      Number of bars displayed: 3 (illuminated)
      60 mm (2.36 in.) diameter pole
      Longest-range detection
      From approx. 600 +/- 60 to 1500 +/- 150 mm (23.6 +/- 2.36 to 59.1 +/- 5.91 in.)
      Buzzer: Sounds intermittently (ON: 0.15 sec. / OFF: 0.65 sec.)
      Number of bars displayed: 4 (illuminated)
      Wall

      HINT:
      Ultrasonic waves are used to measure the detection range; however, the detection range may vary depending on the ambient temperature.