AUTOMATIC TRANSAXLE SYSTEM > DTC CHECK / CLEAR |
| CHECK DTC |
DTCs which are stored in the ECM can be displayed using the intelligent tester.
The intelligent tester can display pending DTCs and current DTCs. Some DTCs are not stored unless a malfunction is detected in consecutive driving cycles. When a malfunction is detected in only one driving cycle, it is stored as a pending DTC.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Confirm the DTCs and freeze frame data, and then write them down.
Confirm the details of the DTCs (Click here).
| CLEAR DTC |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC / Clear.