AUTOMATIC TRANSAXLE SYSTEM > HYDRAULIC TEST |
| PERFORM HYDRAULIC TEST |
![]() |
Measure the line pressure.
Warm up the ATF.
Lift the vehicle.
Remove the engine under cover.
Remove the test plug on the front left side of the transaxle case and install SST.
Lower the vehicle.
Fully apply the parking brake and chock all 4 wheels.
Connect the GTS to the DLC3.
Start the engine.
Enter the following menus: Powertrain / Transmission / Active Test / Control the Shift Position.
Move the shift lever to D, and then use the GTS to perform the Active Test and hold 3rd gear. Measure the line pressure with the engine idling.
| Condition | D Position kPa (kgf/cm2, psi) |
| Idling | 360 to 430 kPa (3.6 to 4.4 kgf/cm2, 52 to 63 psi) |
Turn the engine switch off.
![]() |
Disconnect the connector from the wiring harness connector.
Start the engine.
Depress the brake pedal firmly with your left foot, move the shift lever to D, depress the accelerator pedal as much as possible with your right foot, and quickly read the line pressure when the engine reaches the stall speed.
| Condition | D Position kPa (kgf/cm2, psi) |
| Stall test | 700 to 1100 kPa (7.1 to 11.3 kgf/cm2, 101 to 160 psi) |
Turn the engine switch off.
Connect the connector to the wiring harness connector.
Depress the brake pedal firmly with your left foot, move the shift lever to R, and check the line pressure with the engine idling and then depress the accelerator pedal as much as possible with your right foot and quickly read the line pressure when the engine reaches the stall speed.
| Condition | R Position kPa (kgf/cm2, psi) |
| Idling | 670 to 820 kPa (6.8 to 8.4 kgf/cm2, 97 to 119 psi) |
| Stall test | 1600 to 2000 kPa (16.3 to 20.4 kgf/cm2, 232 to 291 psi) |
Remove SST and install the test plug.
Clear the DTCs (Click here).
| Test Result | Possible Cause |
| Measured values are higher than the specified value in all positions |
|
| Measured values are lower than the specified value in all positions |
|
| Pressure is low in D only |
|
| Pressure is low in R only |
|