Home › Drivetrain ยท U761E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM

AUTOMATIC TRANSAXLE SYSTEM > INITIALIZATION

for Preparation Click here



RESET TRANSAXLE COMPENSATION CODE

NOTICE:
  1. If the following parts have been replaced, initialize the ECM and perform Reset Memory and Perform Road Test to Allow ECM to learn.
    1. Transmission valve body assembly
    2. Shift solenoid valve SL3
    3. Shift solenoid valve SL4
    4. ECM
  2. The transaxle compensation code can only be initialized with the GTS.

HINT:
The ECM (ECT) memorizes the vehicle conditions when controlling the automatic transaxle assembly and engine assembly.
Therefore, if the automatic transaxle assembly, transmission valve body assembly, shift solenoid valve SL3, shift solenoid valve SL4 or ECM has been replaced, it is necessary to reset the memory so that the ECM can memorize the new information. The reset procedure is as follows:

  1. Move the shift lever to N or P.

  2. Turn the engine switch off.

  3. Connect the GTS to the DLC3.

  4. Turn the engine switch on (IG).

  5. Turn the GTS on.

  6. Enter the following menus: Powertrain / Transmission / Utility / A/T Code Reset.

  7. Press "Next" again to proceed.

    NOTICE:
    After the transaxle compensation code is initialized, perform Reset Memory and Perform Road Test to Allow ECM to learn.

  8. Press "Exit".


RESET MEMORY

NOTICE:
Reset Memory can be performed only with the GTS.

HINT:
The ECM (ECT) memorizes the vehicle conditions when controlling the automatic transaxle assembly and engine assembly.
Therefore, if the automatic transaxle assembly, transmission valve body assembly, shift solenoid valve SL3, shift solenoid valve SL4 or ECM has been replaced, it is necessary to reset the memory so that the ECM can memorize the new information. The reset procedure is as follows:

  1. Turn the engine switch off.

  2. Connect the GTS to the DLC3.

  3. Turn the engine switch on (IG).

  4. Turn the GTS on.

  5. Enter the following menus: Powertrain / Transmission / Utility / Reset Memory.

  6. Press "Next".

    NOTICE:
    After performing Reset Memory, be sure to perform Perform Road Test to Allow ECM to Learn.


PERFORM ROAD TEST TO ALLOW ECM TO LEARN

CAUTION:
Perform the following procedure while strictly observing all traffic laws and speed limits.

  1. Warm up the engine.

  2. Turn the engine switch off.

  3. Connect the GTS to the DLC3.

  4. Turn the engine switch on (IG).

  5. Turn the GTS on.

  6. Enter the following menus: Powertrain / Engine / Data List / Throttle Sensor Position.

  7. From a standstill, achieve highest possible speed with the accelerator pedal opened 15% or less. Keep the accelerator pedal opening angle steady while driving the vehicle.

    HINT:
    "Throttle Sensor Position": 15% or less

  8. Repeat the previous step until shift shock no longer occurs.

  9. From a standstill, achieve highest possible speed with the accelerator pedal opened 25% to 35%. Keep the accelerator pedal opening angle steady while driving the vehicle.

    HINT:
    "Throttle Sensor Position": 25% to 35%

  10. Repeat the previous step until shift shock no longer occurs.