MULTIPLEX TILT AND TELESCOPIC ECU > REMOVAL |
| 1. REMOVE FRONT DOOR SCUFF PLATE LH (w/o Driver Side Knee Airbag) |
![]() |
Disengage the 10 claws and remove the front door scuff plate LH.
| 2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH (w/o Driver Side Knee Airbag) |
![]() |
Remove the clip.
Disengage the 2 clips and remove the cowl side trim sub-assembly LH.
| 3. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH (w/o Driver Side Knee Airbag) |
![]() |
Disconnect the front door opening trim weatherstrip LH.
| 4. REMOVE INSTRUMENT SIDE PANEL LH (w/o Driver Side Knee Airbag) |
![]() |
Using a moulding remover, disengage the 4 claws as shown in the illustration.
![]() |
Disengage the 3 guides and remove the instrument side panel LH as shown in the illustration.
| 5. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY (w/o Driver Side Knee Airbag) |
![]() |
Disengage the claw and 2 guides to disconnect the hood lock control lever sub-assembly.
| 6. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY (w/o Driver Side Knee Airbag) |
![]() |
Remove the 2 bolts <B>.
w/o Driver Side Knee Airbag:
![]() |
Disengage the 5 clips and 3 guides to remove the instrument panel sub-assembly.
w/ Driver Side Knee Airbag:
![]() |
Disengage the 4 claws, 7 clips and 3 guides to remove the instrument panel sub-assembly.
| 7. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag) |
| 8. REMOVE MULTIPLEX TILT AND TELESCOPIC ECU |
![]() |
Disconnect the connector from the multiplex tilt and telescopic ECU.
Disengage the wire harness clamp.
![]() |
Disengage the claw to remove the multiplex tilt and telescopic ECU from the steering column assembly.