Home › Engine / Hybrid System · 2AR-FE › STARTING › ENGINE SWITCH

ENGINE SWITCH > INSPECTION

for Preparation Click here



1. INSPECT ENGINE SWITCH



A256118E01

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    5 (SS1) - 6 (GND)
    Not pushed
    10 kΩ or higher
    1 (SS2) - 6 (GND)
    5 (SS1) - 6 (GND)
    Pushed
    Below 1 Ω
    1 (SS2) - 6 (GND)

    If the result is not as specified, replace the engine switch.



  1. Apply battery voltage between the terminals of the switch, and check the illumination condition of the engine switch.

    HINT:
    1. If a positive (+) battery lead and a negative (-) battery lead are incorrectly connected, the engine switch indicator light will not illuminate.
    2. If the voltage is too low, the indicator light will not illuminate.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 9 (SWIL)
    Battery negative (-) → Terminal 6 (GND)
    Illuminates



    A256118E02


    Text in Illustration 
    *a
    Indicator Light
    If the result is not as specified, replace the engine switch.