Home › Engine / Hybrid System · 6AR-FSE › STARTING › ENGINE SWITCH

ENGINE SWITCH > INSPECTION

for Preparation Click here



1. INSPECT ENGINE SWITCH


    A295732E03
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Engine Switch)

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    5 (SS1) - 6 (AGND)
    1 (SS2) - 6 (AGND)
    Not pushed
    10 kΩ or higher
    Pushed
    Below 1 Ω

    If the result is not as specified, replace the engine switch.

  1. Apply battery voltage between the terminals of the engine switch, and check the illumination condition of the engine switch indicator light.

    OK:
    Condition
    Specified Condition
    Battery positive (+) → Terminal 9 (SWIL)
    Battery negative (-) → Terminal 6 (AGND)
    Illuminates

    HINT:
    1. If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator light will not illuminate.
    2. If the voltage is too low, the engine switch indicator light will not illuminate.

    If the result is not as specified, replace the engine switch.