Home › Vehicle Interior › SEAT › RELAY

RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT SEAT HEATER R/L RELAY


    E209082
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω
    3 - 5
    Battery voltage not applied between terminals
    10 kΩ or higher

    If the result is not as specified, replace the seat heater relay LH.



2. REMOVE SEAT HEATER R/R RELAY


    E209082
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω
    3 - 5
    Battery voltage not applied between terminals
    10 kΩ or higher

    If the result is not as specified, replace the seat heater relay RH.