Home › Vehicle Interior › SEAT BELT › REAR SEAT INNER BELT ASSEMBLY (for TMC, TMMR Made)

REAR SEAT INNER BELT ASSEMBLY (for TMC, TMMR Made) > ON-VEHICLE INSPECTION

for Preparation Click here


CAUTION:
Be sure to correctly follow the removal and installation procedures for the rear seat inner with center belt assembly LH.



1. INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH (for Vehicle not Involved in Collision)
  1. Perform a diagnostic system check (Click here).

  1. Visually check for defects with the rear seat inner with center belt assembly LH installed on the vehicle.

    1. The defects are as follows:

      1. Cuts on the rear seat inner with center belt assembly LH
      2. Small cracks on the rear seat inner with center belt assembly LH
      3. Significant discoloration on the rear seat inner with center belt assembly LH

      OK:
      No defects are found.

      HINT:
      If any of the defects is found, replace the rear seat inner with center belt assembly LH with a new one.



2. INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH (for Vehicle Involved in Collision)
  1. Perform a diagnostic system check (Click here).

  1. Visually check for defects with the rear seat inner with center belt assembly LH removed from the vehicle.

    1. The defects are as follows:

      1. Cuts on the rear seat inner with center belt assembly LH
      2. Small cracks on the rear seat inner with center belt assembly LH
      3. Significant discoloration on the rear seat inner with center belt assembly LH
      4. Cracks or other damage to the connector

      OK:
      No defects are found.

      HINT:
      If any of the defects is found, replace the rear seat inner with center belt assembly LH with a new one.