Home › Vehicle Exterior › WINDOW / GLASS › RELAY

RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT DEICER RELAY


    B280991
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage applied between terminals 1 and 2
    Below 1 Ω
    3 - 5
    Battery voltage not applied between terminals 1 and 2
    10 kΩ or higher

    If the result is not as specified, replace the DEICER relay.



2. INSPECT HWD NO. 1 RELAY


    B373390
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage applied between terminals 1 and 2
    Below 1 Ω
    3 - 5
    Battery voltage not applied between terminals 1 and 2
    10 kΩ or higher

    If the result is not as specified, replace the HWD1 relay.



3. INSPECT HWD NO. 2 RELAY


    B373390
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage applied between terminals 1 and 2
    Below 1 Ω
    3 - 5
    Battery voltage not applied between terminals 1 and 2
    10 kΩ or higher

    If the result is not as specified, replace the HWD2 relay.