Home › Vehicle Exterior › LIGHTING (EXT) › AFS (ADAPTIVE FRONT-LIGHTING SYSTEM)

AFS (ADAPTIVE FRONT-LIGHTING SYSTEM) > AFS OFF Switch Circuit

for Preparation Click here


DESCRIPTION

When the headlight swivel main switch is pushed (ON), the AFS ECU (headlight swivel ECU assembly) will cancel the intelligent AFS control and turn on the AFS OFF indicator light.

WIRING DIAGRAM


E220288E05


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / AFS / Data List.

  1. Read the display on the intelligent tester.

    AFS 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    AFS OFF Switch
    Headlight swivel main switch signal/ ON or OFF
    ON: Headlight swivel main switch pushed
    OFF: Headlight swivel main switch not pushed
    -

    OK:
    Normal conditions listed above are displayed.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT HEADLIGHT SWIVEL MAIN SWITCH
  1. Remove the headlight swivel main switch (Click here).



    E136319E39
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 4
    Not pushed (OFF)
    10 kΩ or higher
    Pushed (ON)
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Headlight Swivel Main Switch)



NG
REPLACE HEADLIGHT SWIVEL MAIN SWITCH (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (HEADLIGHT SWIVEL MAIN SWITCH - AFS ECU)
  1. Disconnect the A35 AFS ECU (headlight swivel ECU assembly) connector.

  1. Disconnect the I180 headlight swivel main switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A35-32 (MSW) - I180-4
    Always
    Below 1 Ω
    A35-32 (MSW) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (HEADLIGHT SWIVEL MAIN SWITCH - BODY GROUND)
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I180-1 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) (Click here)