HOOD (for TMMK Made) > ADJUSTMENT |

| *a | Centering Bolt |
| *b | Standard Bolt |
| 1. INSPECT HOOD SUB-ASSEMBLY |
Check that the clearance measurements of areas a through d are within each standard range.

| Area | Measurement | Area | Measurement |
| a | 1.85 to 5.85 mm (0.0728 to 0.230 in.) | b | 7.15 to 11.15 mm (0.281 to 0.439 in.) |
| c | 2.0 to 5.0 mm (0.0787 to 0.197 in.) | d | -1.5 to 1.5 mm (-0.0591 to 0.0591 in.) |
| 2. ADJUST HOOD SUB-ASSEMBLY |
Horizontally and vertically adjust the hood.
![]() |
Loosen the 4 hinge bolts of the hood.
Adjust the clearance between the hood and front fender by moving the hood.
Tighten the 4 hinge bolts after the adjustment.
Adjust the height of the front end of the hood using the cushion rubbers.
![]() |
Adjust the 2 cushion rubbers so that the heights of the hood and fender are aligned.
Remove the cool air intake duct seal .
Adjust the hood lock.
![]() |
Using a screwdriver, remove the hood lock nut cap.
| *a | Protective Tape |
![]() |
Loosen the 2 bolts and hood lock bolt.
| *1 | Hood Lock Bolt |
![]() |
Adjust the hood lock and tighten the 2 bolts and hood lock bolt.
Check that the striker can engage with the hood lock smoothly.
Install a new hood lock nut cap.
Install the cool air intake duct seal .