Home › Vehicle Exterior › DOOR / HATCH › LUGGAGE COMPARTMENT DOOR (for TMMK Made)

LUGGAGE COMPARTMENT DOOR (for TMMK Made) > ADJUSTMENT

for Preparation Click here



1. REMOVE LUGGAGE COMPARTMENT DOOR COVER


    B380679
  1. Remove the 13 clips and luggage compartment door cover.



2. REMOVE SPARE WHEEL COVER ASSEMBLY
  1. Remove the spare wheel cover assembly.



3. REMOVE REAR FLOOR FINISH PLATE


    B380707
  1. Remove the 5 clips.



    B380708
  1. Disengage the 4 clips and remove the rear floor finish plate as shown in the illustration.



4. REMOVE LUGGAGE COMPARTMENT DOOR HINGE COVER LH


    B380681
  1. Remove the 2 clips.

  1. Disengage the clip and remove the luggage compartment door hinge cover LH.



5. REMOVE LUGGAGE COMPARTMENT DOOR HINGE COVER RH

HINT:
Use the same procedure as for the LH side.



6. ADJUST LUGGAGE COMPARTMENT DOOR


    B280559
  1. Loosen the door side hinge bolts to adjust the door horizontally and vertically.

    Torque:
    7.5 N*m{ 77 kgf*cm , 66 in.*lbf }



    B280560
  1. Using a T40 "TORX" socket wrench, slightly loosen the striker mounting screws.

  1. Using a brass bar and a hammer, hit the striker to adjust its position.

  1. Using a T40 "TORX" socket wrench, tighten the striker mounting screws after adjustment.

    Torque:
    23 N*m{ 235 kgf*cm , 17 ft.*lbf }



7. INSTALL LUGGAGE COMPARTMENT DOOR HINGE COVER LH


    B380681
  1. Engage the clip.

  1. Install the luggage compartment door hinge cover LH with the 2 clips.



8. INSTALL LUGGAGE COMPARTMENT DOOR HINGE COVER RH

HINT:
Use the same procedure as for the LH side.



9. INSTALL REAR FLOOR FINISH PLATE


    B380709
  1. Engage the 4 clips to install the rear floor finish plate as shown in the illustration.

  1. Install the 5 clips.



10. INSTALL SPARE WHEEL COVER ASSEMBLY
  1. Install the spare wheel cover assembly.



11. INSTALL LUGGAGE COMPARTMENT DOOR COVER


    B380679
  1. Install the luggage compartment door cover with the 13 clips.



12. INSPECT LUGGAGE COMPARTMENT DOOR


  1. Check that the clearance measurements of areas a through d are within each standard range.


    B402435E01


    Standard Clearance 
    Area
    Measurement
    Area
    Measurement
    a
    6.15 mm (0.242 in.)
    b
    2.0 to 5.0 mm (0.0787 to 0.197 in.)
    c
    -1.2 to 1.8 mm (-0.0472 to 0.0709 in.)
    d
    6.05 mm (0.238 in.)