DTC B2274 ACC Monitor Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area | DTC Output Confirmation Operation |
| B2274 | Malfunction in the ACC relay circuit in the certification ECU (smart key ECU assembly) or in the external circuit (1-trip detection logic*).
|
| Wait 10 seconds after turning the engine switch on (ACC) or on (IG), and then wait another 10 seconds after turning the engine switch off. |
| Vehicle Condition when Malfunction Detected | Fail-safe Function when Malfunction Detected |
| - |

| DTC | Data List Item | Active Test Item |
| B2274 | Power Source Control
Starting Control
| - |
| 1.CHECK HARNESS AND CONNECTOR (POWER SOURCE) |
![]() |
Disconnect the A43 connector from the certification ECU (smart key ECU assembly).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A43-2 (+B) - Body ground | Always | 11 to 14 V |
| *a | Rear view of wire harness connector (to Certification ECU (smart key ECU assembly)) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A43-11 (E) - Body ground | Always | Below 1 Ω |
| *a | Rear view of wire harness connector (to Certification ECU (smart key ECU assembly)) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY) |
Disconnect the I78 connector from the certification ECU (smart key ECU assembly).
Disconnect the 3B connector from the instrument panel junction block assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I78-4 (ACCD) - 3B-23 | Always | Below 1 Ω |
| 3B-7 - Body ground | Always | Below 1 Ω |
| I78-4 (ACCD) or 3B-23 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (ACC RELAY) |
Remove the instrument panel junction block assembly (Click here).

| *a | Component without harness connected (Instrument Panel Junction Block Assembly) | - | - |
Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Battery voltage not applied to terminals 3B-23 and 3B-7 | 10 kΩ or higher |
| Battery voltage applied to terminals 3B-23 and 3B-7 | Below 1 Ω |
|
| ||||
| OK | |
| 5.INSPECT CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |
![]() |
Reconnect the I78 certification ECU (smart key ECU assembly) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I78-4 (ACCD) - Body ground | Engine switch off → Engine switch on (ACC) | 1 V or less → 8.5 V or higher |
| *a | Component with harness connected (Certification ECU (Smart Key ECU Assembly)) |
|
| ||||
| OK | ||
| ||