Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM (for TMMK Made)

AIRBAG SYSTEM (for TMMK Made) > CHECK MODE PROCEDURE

for Preparation Click here



CHECK MODE (SIGNAL CHECK): DTC CHECK
  1. Turn the engine switch off.

  2. Connect the GTS to the DLC3.

  3. Turn the engine switch on (IG).

  4. Turn the GTS on.

  5. Enter the following menus: Body Electrical / SRS Airbag / Utility / Signal Check, and proceed with checking using the GTS.

    NOTICE:
    Select Signal Check screen on the GTS to clear the output DTCs (both current and history).

    HINT:
    1. DTCs can be detected more sensitively in check mode than in normal diagnosis mode.
    2. Perform check mode inspection when a malfunction in a squib circuit is suspected even after the normal system code is output through normal diagnosis mode inspection.