VEHICLE STABILITY CONTROL SYSTEM > CHECK FOR INTERMITTENT PROBLEMS |
| CHECK FOR INTERMITTENT PROBLEMS |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Follow the directions on the intelligent tester to display the Data List and select areas where momentary interruption should be monitored.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| EFI Communication Open | EFI communication open detection / Error or Normal | Error: Momentary interruption Normal: Normal | - |
| Yaw Rate Open | Yaw rate sensor open detection / Error or Normal | Error: Momentary interruption Normal: Normal | - |
| Deceleration Open | Acceleration sensor open detection / Error or Normal | Error: Momentary interruption Normal: Normal | - |
| Steering Open | Steering angle sensor open detection / Error or Normal | Error: Momentary interruption Normal: Normal | - |
| IG Voltage Value Decreased | +BS voltage value decrease detection / Error or Normal | Error: Voltage low Normal: Normal | - |
| IG Voltage Value Increased | +BS voltage value increase detection / Error or Normal | Error: Voltage high Normal: Normal | - |
While observing the screen, gently jiggle the connector or wire harness between the ECU and sensors, or between ECUs.