Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > FREEZE FRAME DATA

for Preparation Click here



FREEZE FRAME DATA
  1. Whenever a meter DTC is detected, the combination meter assembly stores the current vehicle state as freeze frame data.


CHECK FREEZE FRAME DATA
  1. Connect the GTS to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the GTS on.

  4. Enter the following menus: Body Electrical / Combination Meter / Trouble Codes.

  5. According to the GTS display, select a DTC that stored freeze frame data.

  6. Read the freeze frame data recorded when the DTC was stored.

    Combination Meter 
    Tester Display
    Condition
    Displayed Item
    B1507
    Open in Turn Signal Circuit
    1. Trip
    2. Elapsed time after turning the ignition switch to ON
    B1508
    Short in Turn Signal / Hazard Flasher Circuit
    B150A*1, *2
    Lost Communication with HMI-LAN
    U0100
    Lost Communication with ECM / PCM "A"
    U0129
    Lost Communication with Skid Control ECU
    U0131
    Lost Communication with Power Steering Control Module
    U0142
    Lost Communication with Main Body ECU
    U0151
    Lost Communication with Airbag ECU
    U0163*3
    Lost Communication with Navigation Control Module

    1. *1: for Navigation Receiver Type
    2. *2: for Radio and Display Type
    3. *3: w/ Navigation System


CLEAR FREEZE FRAME DATA

NOTICE:
Clearing the DTCs will also clear the freeze frame data.

  1. Connect the GTS to the DLC3.

  2. Turn the ignition switch to ON.

  3. Clear the DTCs and freeze frame data (Click here).