SMART ENTRY AND START SYSTEM (for Start Function) > SYSTEM DESCRIPTION |
| SYSTEM FUNCTION |
| Function | Outline |
| Push-button start function | When the key is brought into the vehicle and verified, this function changes the power source or starts the engine when the engine switch and brake pedal are operated. |
| Battery saving function for vehicle | When the vehicle is not used for a long time, this function extends the interval between each periodic transmission of the request signal, or stops transmission of the request signal to save vehicle battery power.
|
| Battery saving function for key | If a switch on the key is depressed and held, this function stops transmission of the signal after approximately 20 seconds to save key battery power. |
| Key cancel function | Cancels the smart entry and start system when certain operations are performed. |
| Immobiliser function | Allows the engine to be started only using registered keys to prevent an unauthorized engine start. |
| Automatic power off function | With the shift lever in P and the engine switch on (ACC) or on (IG) (the engine is not started and the vehicle is not moving), the power automatically turns off when the vehicle is left as is for 60 minutes or more. |
| DETECTION AREA |
The request signal sent from the certification ECU (smart key ECU assembly) is transmitted from each electrical key antenna (outside) to form the smart key detection area. The detection area formed by each electrical key antenna (outside) has a detection range of 0.7 to 1 m (2.30 to 3.28 ft.) from the door handles and rear bumper (electrical key antenna [outside luggage]).
When the vehicle is parked (the power source mode is off and the doors are locked*), the detection area of each electrical key antenna (outside) is formed by emitting a periodic request signal every 0.25 seconds in order to detect the key. Also, when the doors are locked and a lock sensor is touched, a request signal is emitted, the detection area outside the vehicle is formed and the key is detected.
The detection area of the electrical key antenna (outside luggage) is formed when the luggage door opening switch assembly is pressed.
The detection area inside the vehicle is formed and the key is detected when any of the following conditions are met: 1) The driver door is opened and closed, 2) the brake pedal is depressed, 3) the engine switch is operated, 4) the conditions required for various warnings are met, or 5) a smart door lock operation is performed.
The detection area inside the vehicle when starting the engine can be customized through the customize function.