Home › Vehicle Interior › SEAT › SEAT MEMORY SWITCH (for TMMR Made)

SEAT MEMORY SWITCH (for TMMR Made) > INSPECTION

for Preparation Click here



1. INSPECT SEAT MEMORY SWITCH


    B295109E01
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *1
    M1 Switch
    *2
    M2 Switch
    *3
    SET Switch
    *a
    Component without harness connected
    (Seat Memory Switch)

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    2 - 1
    SET switch is pressed
    Below 1 Ω
    4 - 1
    M1 switch is pressed
    Below 1 Ω
    3 - 1
    M2 switch is pressed
    Below 1 Ω
    2 - 1
    SET switch is not pressed
    10 kΩ or higher
    4 - 1
    M1 switch is not pressed
    10 kΩ or higher
    3 - 1
    M2 switch is not pressed
    10 kΩ or higher

    If the result is not as specified, replace the seat memory switch.