Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK TIRE PRESSURE WARNING ECU AND RECEIVER


    C250865E58
  1. Disconnect the N47 tire pressure warning ECU and receiver connector and measure the voltage or resistance on the wire harness side.
    Text in Illustration  
    *a
    Front view of wire harness connector
    (to Tire Pressure Warning ECU and Receiver)

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    N47-1 (IG) - N47-12 (GND)
    V - BR
    IG power source
    Engine switch on (IG)
    10 to 16 V
    N47-12 (GND) - Body ground
    BR - Body ground
    Ground
    Always
    Below 1 Ω

  2. Connect the N47 tire pressure warning ECU and receiver connector.



  3. Measure the voltage and resistance according to the value(s) in the table below. If the result is not as specified, the ECU may be malfunctioning.

    HINT:
    Inspect the connectors from the back side while the connectors are connected.


    E129452E99


    Text in Illustration  
    *a
    Component with harness connected
    (Tire Pressure Warning ECU and Receiver)
    -
    -

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    N47-3 (CLSW) - N47-12 (GND)
    R - BR
    Tire pressure warning reset switch
    1. Engine switch on (IG)
    2. Tire pressure warning reset switch on
    Below 1.5 V
    1. Engine switch on (IG)
    2. Tire pressure warning reset switch off
    8 to 15 V
    N47-4 (RDA2) - N47-12 (GND)
    L - BR
    Output signals
    Engine switch on (IG)
    Pulse generation (see waveform 1)
    N47-5 (PRG2) - N47-12 (GND)
    P - BR
    Input signals
    Engine switch on (IG)
    Pulse generation (see waveform 1)



  4. C240058E01
  5. Using an oscilloscope, check waveform 1.
    Text in Illustration 
    *a
    Example
    *b
    GND
    Waveform 1: 
    Item
    Contents
    Terminal
    N47-4 (RDA2) - N47-12 (GND)
    N47-5 (PRG2) - N47-12 (GND)
    Tool setting
    5 V/DIV, 5 ms./DIV.
    Vehicle condition
    Engine switch on (IG)

    HINT:
    The waveform shown in the illustration is an example. If the tester displays a waveform that alternates between high and low, where high is a voltage that is between the IG power source voltage and a voltage 2.2 V lower than the IG power source voltage, and where low is a voltage of between 0 and 1.2 V, the ECU can be judged normal.