PUSH-BUTTON START > Key Luggage Compartment Lock-in Prevention Function does not Operate |

| 1.CHECK ENTRY FUNCTION (ENTRY LUGGAGE COMPARTMENT OPEN FUNCTION) |
Check that the entry luggage compartment open function operates (Click here).
| Result | Proceed to |
| Entry luggage compartment door open function operates | A |
| Entry luggage compartment door open function does not operate | B |
|
| ||||
| A | |
| 2.CHECK WAVE ENVIRONMENT |
![]() |
Bring the electrical key transmitter sub-assembly near the No. 3 indoor electrical key antenna assembly (inside luggage compartment), and check that the entry luggage compartment lock-in prevention function operates.
| *a | Inspection Point |
|
| ||||
| OK | ||
| ||
| 3.CHECK KEY DIAGNOSTIC MODE |
Check the following antennas in the key diagnostic mode (Click here).
![]() |
Select either channel 1 or channel 2 and inspect the key diagnostic mode for each channel.
| *a | Inspection Point |
When the electrical key transmitter sub-assembly is held at the same height as the rear bumper upper surface and aligned with the center of the rear of the vehicle, check that the wireless door lock buzzer sounds.
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - NO. 3 INDOOR ELECTRICAL KEY ANTENNA) |
Disconnect the O1 certification ECU (smart key ECU assembly) connector.
Disconnect the N38 No. 3 indoor electrical key antenna assembly (inside luggage compartment) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O1-9 (CLG7) - N38-1 (CLG6) | Always | Below 1 Ω |
| O1-8 (CG7B) - N38-3 (CLGB) | Always | Below 1 Ω |
| O1-9 (CLG7) or N38-1 (CLG6) - Body ground | Always | 10 kΩ or higher |
| O1-8 (CG7B) or N38-3 (CLGB) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |
Connect the N38 certification ECU (smart key ECU assembly) connector.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Tool Setting | Specified Condition |
| N38-1 (CLG6) - N38-3 (CLGB) | Procedure:
| 2 V/DIV., 500 ms/DIV. | Pulse generation (See waveform) |
| *1 | Waveform |
| *a | Front view of wire harness connector (to No. 3 Indoor Electrical Key Antenna Assembly (inside luggage compartment)) |
| *b | Driver door lock sensor not touched |
| *c | Driver door lock sensor touched |
|
| ||||
| OK | |
| 6.REPLACE NO. 3 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (INSIDE LUGGAGE COMPARTMENT) |
Replace the No. 3 indoor electrical key antenna assembly (inside luggage compartment) (Click here).
| NEXT | |
| 7.CHECK NO. 3 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (INSIDE LUGGAGE COMPARTMENT) |
Check that the entry luggage compartment lock-in prevention function operates normally (Click here).
|
| ||||
| OK | ||
| ||