Home › Engine / Hybrid System ยท 6AR-FSE › COOLING › COOLING FAN SYSTEM

COOLING FAN SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT COOLING FAN SYSTEM OPERATION AT LOW TEMPERATURES
  1. Check and ensure the following conditions:

    1. Turn the engine switch off.

    2. The engine coolant temperature is less than 96°C (205°F).

    3. The A/C switch is off.

  1. Turn the engine switch to on (IG) and wait for approximately 10 seconds. Check that the fans are not operating.

  1. Check that the fans operate when the water temperature sensor connector is disconnected.



2. INSPECT COOLING FAN SYSTEM OPERATION AT HIGH TEMPERATURES
  1. Check and ensure the following conditions:

    1. Warm up the engine.

    2. The engine coolant temperature is less than 96°C (205°F).

    3. The A/C switch is off.

  1. Start the engine. Check that the fans are not operating.

  1. Check that the fans start operating when the engine coolant temperature reaches approximately 98°C (208°F).

    HINT:
    This system can also be checked using the GTS. Enter the following menus: Powertrain / Engine / Data List / Coolant Temperature.