Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY (for TMMK Made)

HOOD LOCK CONTROL CABLE ASSEMBLY (for TMMK Made) > REMOVAL

for Preparation Click here



1. REMOVE COOL AIR INTAKE DUCT SEAL


    B400895
  1. Remove the 9 clips and cool air intake duct seal.



2. REMOVE FRONT WHEEL LH


3. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

HINT:
Use the same procedure as for the RH side .



4. REMOVE FRONT FENDER LINER LH

HINT:
Use the same procedure as for the RH side .



5. REMOVE FRONT DOOR SCUFF PLATE LH


    B395175E01
  1. Disengage the 2 claws (A) in the direction indicated by the arrows (1) shown in the illustration.

  1. Disengage the 2 claws (B) in the direction indicated by the arrows (2) shown in the illustration.

  1. Disengage the 6 claws (C) to remove the front door scuff plate LH.



6. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH


    B278978
  1. Remove the clip.

  1. Pull the cowl side trim sub-assembly LH as shown in the illustration to disengage the 2 clips and remove the cowl side trim sub-assembly LH.



7. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B279865
  1. Disengage the claw and 2 guides to disconnect the hood lock control lever sub-assembly.



8. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B277166
  1. Disconnect the hood lock control cable assembly and remove the hood lock control lever sub-assembly.



9. REMOVE HOOD LOCK ASSEMBLY


    B382415E01
  1. Using a screwdriver, remove the hood lock nut cap.
    Text in Illustration 
    *a
    Protective Tape

    HINT:
    Tape the screwdriver tip before use.



  1. w/ Engine Hood Courtesy Switch:



      B381594
    1. Disconnect the connector.



    B380676E01
  1. Remove the 2 bolts and hood lock bolt.
    Text in Illustration 
    *1
    Hood Lock Bolt



    B380677
  1. Disconnect the hood lock control cable assembly and remove the hood lock assembly.



10. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY


  1. Using a screwdriver, disengage 5 clamps and hood cable grommet as shown in the illustration.


    B402694E01


    Text in Illustration 
    *1
    Hood Lock Control Cable Assembly
    *2
    Washer Hose
    *a
    Hood Cable Grommet
    *b
    Hood Lock Control Cable Clamp

    HINT:
    Tape the screwdriver tip before use.

  1. Pull the hood lock control cable assembly from the engine compartment and remove it.