SMART ENTRY AND START SYSTEM (for Start Function) > DTC CHECK / CLEAR |
| CHECK FOR DTC (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) [POWER SOURCE CONTROL]) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Power Source Control / DTC.
Check for DTCs.
| CHECK FOR DTC (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) [STARTING CONTROL]) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Starting Control / DTC.
Check for DTCs.
| CHECK FOR DTC (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) [ENTRY & START]) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Entry & Start / DTC.
Check for DTCs.
| CHECK FOR DTC (TELEPHONE TRANSCEIVER ASSEMBLY [TELEMATICS TRANSCEIVER])* |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Telematics Transceiver / DTC.
Check for DTCs.
| CLEAR DTC (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) [POWER SOURCE CONTROL]) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Power Source Control / DTC / Clear.
Clear the DTCs by following the directions on the intelligent tester display.
| CLEAR DTC (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) [STARTING CONTROL]) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Starting Control / DTC / Clear.
Clear the DTCs by following the directions on the intelligent tester display.
| CLEAR DTC (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) [ENTRY & START]) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Entry & Start / DTC / Clear.
Clear the DTCs by following the directions on the intelligent tester display.
| CLEAR DTC (TELEPHONE TRANSCEIVER ASSEMBLY [TELEMATICS TRANSCEIVER])* |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Telematics Transceiver / DTC / Clear.
Clear the DTCs by following the directions on the intelligent tester display.