SLIDING ROOF SWITCH ASSEMBLY > INSPECTION |
| 1. INSPECT SLIDING ROOF SWITCH (ROOF CONSOLE BOX ASSEMBLY) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 5 (UP) - 1 (GND) | UP switch is pressed | Below 1 Ω |
| 5 (UP) - 1 (GND) | UP switch is not pressed | 10 kΩ or higher |
| 4 (DOWN) - 1 (GND) | DOWN switch is pressed | Below 1 Ω |
| 4 (DOWN) - 1 (GND) | DOWN switch is not pressed | 10 kΩ or higher |
| 3 (OPN) - 1 (GND) | OPEN switch is pressed | Below 1 Ω |
| 3 (OPN) - 1 (GND) | OPEN switch is not pressed | 10 kΩ or higher |
| 2 (CLS) - 1 (GND) | CLOSE switch is pressed | Below 1 Ω |
| 2 (CLS) - 1 (GND) | CLOSE switch is not pressed | 10 kΩ or higher |
| *a | Component without harness connected (Sliding Roof Switch (Roof Console Box Assembly)) |