Home › Engine / Hybrid System ยท 2GR-FE › STARTING › STARTER

STARTER > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



2. REMOVE COOL AIR INTAKE DUCT SEAL


    B382622
  1. Remove the 9 clips and cool air intake duct seal.



3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



4. REMOVE V-BANK COVER SUB-ASSEMBLY


    A255420
  1. Hold the front of the V-bank cover sub-assembly and raise it to disengage the 2 retainers on the front of the V-bank cover sub-assembly. Continue to raise the V-bank cover sub-assembly to disengage the retainer on the rear of the V-bank cover sub-assembly and remove the V-bank cover sub-assembly.

    NOTICE:
    Attempting to disengage both front and rear retainers at the same time may cause the V-bank cover sub-assembly to break.



5. REMOVE INLET NO. 2 AIR CLEANER


    A255421
  1. Disconnect the 2 wire harness clamps and vacuum hose clamp.

  1. Remove the 2 bolts and inlet No. 2 air cleaner.



6. REMOVE BATTERY


    A256224
  1. Disconnect the positive (+) cable from the positive (+) battery terminal.

  1. Loosen the nut and remove the bolt.

  1. Remove the battery and battery tray.



7. REMOVE INLET NO. 1 AIR CLEANER


    A256225
  1. Disengage the pin and remove the inlet No. 1 air cleaner.



8. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A254996
  1. Disconnect the mass air flow meter connector and wire harness clamp.



    A254997
  1. Disconnect the 3 hoses.

  1. Separate the ventilation hose.



    A254998
  1. Loosen the hose clamp and separate the air cleaner cap sub-assembly from the throttle with motor body assembly.

  1. Release the 2 clamps and remove the air cleaner cap with hose.



9. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY


10. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    A255892
  1. Disconnect the wire harness clamp, connector, vacuum hose and No. 1 fuel vapor feed hose.

  1. Remove the 2 bolts and air cleaner case sub-assembly.



11. REMOVE STARTER ASSEMBLY


    A255475
  1. Disconnect the starter connector.

  1. Remove the terminal cap.

  1. Remove the nut and disconnect the starter wire.



    A255476
  1. Remove the 2 bolts and starter assembly.