Home › Engine / Hybrid System ยท 2GR-FE › STARTING › STARTER

STARTER > DISASSEMBLY

for Preparation Click here



1. REMOVE REPAIR SERVICE STARTER KIT


    A079718
  1. Remove the nut and disconnect the lead wire from the magnet switch.



    A079719
  1. Holding the magnet switch to the starter drive housing, remove the 2 screws.

  1. Remove the magnet switch.

  1. Remove the return spring and plunger from the starter drive housing.



2. REMOVE STARTER YOKE ASSEMBLY


    A079720
  1. Remove the 2 through-bolts, and pull out the starter yoke assembly together with the starter commutator end frame assembly.



    A079721
  1. Remove the starter yoke assembly from the starter commutator end frame assembly.



3. REMOVE STARTER ARMATURE PLATE


    A079722
  1. Remove the armature plate from the starter yoke assembly.



4. REMOVE STARTER COMMUTATOR END FRAME COVER


    A079723
  1. Using a screwdriver, pry out the commutator end frame cover.



5. REMOVE STARTER ARMATURE ASSEMBLY


    A082440E09
  1. Using snap ring pliers, remove the snap ring and washer.

    NOTICE:
    Do not drop the starter armature assembly.

    Text in Illustration 
    *1
    Snap Ring Pliers

  1. Remove the starter armature assembly from the starter commutator end frame assembly.



6. REMOVE PLANETARY GEAR


    A081167
  1. Remove the 3 planetary gears from the starter drive housing.