STARTER > DISASSEMBLY |
| 1. REMOVE REPAIR SERVICE STARTER KIT |
![]() |
Remove the nut, and disconnect the field coil lead wire from terminal C.
![]() |
While holding the repair service starter kit to the No. 2 repair service starter kit, remove the 2 screws.
Remove the magnet switch from the No. 2 repair service starter kit.
Remove the return spring and plunger from the No. 2 repair service starter kit.
| 2. REMOVE STARTER YOKE ASSEMBLY |
![]() |
Remove the 2 through bolts and pull out the starter yoke assembly together with the starter commutator end frame assembly.
| *1 | Starter Yoke Assembly |
| *2 | Starter Commutator End Frame Assembly |
| 3. REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY |
![]() |
Remove the starter commutator end frame assembly from the starter yoke assembly.
| *1 | Starter Yoke Assembly |
| *2 | Starter Commutator End Frame Assembly |
| 4. REMOVE STARTER ARMATURE PLATE |
![]() |
Remove the starter armature plate from the starter yoke assembly.
| *1 | Starter Yoke Assembly |
| *2 | Starter Armature Plate |
| 5. REMOVE STARTER COMMUTATOR END FRAME COVER |
![]() |
Using a screwdriver, pry out the starter commutator end frame cover from the starter commutator end frame assembly.
| 6. REMOVE STARTER ARMATURE ASSEMBLY |
![]() |
Secure the starter commutator end frame assembly in a vise between aluminum plates.
| *a | Snap Ring Pliers |
Using snap ring pliers, remove the snap ring and washer.
Remove the starter armature assembly from the starter commutator end frame assembly.
| 7. REMOVE PLANETARY GEAR |
![]() |
Remove the 3 planetary gears from the No. 2 repair service starter kit.