DTC B1617/84 Lost Communication with Front Airbag Sensor LH |
DTC B1618/84 Front Airbag Sensor LH Initialization Incomplete |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1617/84 B1618/84 |
|
|

| 1.CHECK CONNECTORS |
Turn the engine switch off.
Disconnect the cable from the negative (-) battery terminal.
Check that the connectors are properly connected to the airbag sensor assembly and front airbag sensor LH. Also check that the connectors that link the engine room main wire and instrument panel wire are properly connected.
Disconnect the connectors from the airbag sensor assembly and front airbag sensor LH. Also disconnect the connectors that link the engine room main wire and instrument panel wire.
Check that the terminals of the connectors are not damaged.
|
| ||||
| OK | |
| 2.CHECK FRONT AIRBAG SENSOR LH CIRCUIT (OPEN) |
![]() |
Connect the connectors that link the engine room main wire and instrument panel wire.
Using a service wire, connect terminals 30 (+SL) and 28 (-SL) of connector B.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A12-2 (+SL) - A12-1 (-SL) | Always | Below 1 Ω |
| *1 | Front Airbag Sensor LH |
| *2 | Airbag Sensor Assembly |
| *3 | Service Wire |
| *a | Front view of wire harness connector (to Airbag Sensor Assembly) |
| *b | Front view of wire harness connector (to Front Airbag Sensor LH) |
|
| ||||
| OK | |
| 3.CHECK FRONT AIRBAG SENSOR LH CIRCUIT (SHORT) |
![]() |
Disconnect the service wire from connector B.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A12-2 (+SL) - A12-1 (-SL) | Always | 1 MΩ or higher |
| *1 | Front Airbag Sensor LH |
| *2 | Airbag Sensor Assembly |
| *a | Front view of wire harness connector (to Front Airbag Sensor LH) |
|
| ||||
| OK | |
| 4.CHECK FRONT AIRBAG SENSOR LH CIRCUIT (SHORT TO B+) |
![]() |
Connect the cable to the negative (-) battery terminal.
Turn the engine switch on (IG).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A12-2 (+SL) - Body ground | Engine switch on (IG) | Below 1 V |
| A12-1 (-SL) - Body ground | Engine switch on (IG) | Below 1 V |
Turn the engine switch off.
Disconnect the cable from the negative (-) battery terminal.
| *1 | Front Airbag Sensor LH |
| *2 | Airbag Sensor Assembly |
| *a | Front view of wire harness connector (to Front Airbag Sensor LH) |
|
| ||||
| OK | |
| 5.CHECK FRONT AIRBAG SENSOR LH CIRCUIT (SHORT TO GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A12-2 (+SL) - Body ground | Always | 1 MΩ or higher |
| A12-1 (-SL) - Body ground | Always | 1 MΩ or higher |
| *1 | Front Airbag Sensor LH |
| *2 | Airbag Sensor Assembly |
| *a | Front view of wire harness connector (to Front Airbag Sensor LH) |
|
| ||||
| OK | |
| 6.CHECK FRONT AIRBAG SENSOR LH |
![]() |
Connect the connector to the airbag sensor assembly.
Interchange the front airbag sensor LH with RH and connect the connectors.
Connect the cable to the negative (-) battery terminal.
Clear the DTCs stored in memory (Click here).
Turn the engine switch off.
Turn the engine switch on (IG), and wait for at least 60 seconds.
Check for DTCs (Click here).
| Result | Proceed to |
| DTCs B1612/83, B1613/83, B1617/84 and B1618/84 are not output. | A |
| DTC B1617/84 or B1618/84 is output. | B |
| DTC B1612/83 or B1613/83 is output. | C |
Turn the engine switch off.
Disconnect the cable from the negative (-) battery terminal.
Return the front airbag sensor LH and RH to their original positions and connect the connectors.
| *1 | Front Airbag Sensor RH |
| *2 | Airbag Sensor Assembly |
|
| ||||
|
| ||||
| A | ||
| ||
| 7.CHECK INSTRUMENT PANEL WIRE (OPEN) |
![]() |
Disconnect the instrument panel wire connector from the engine room main wire.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| IA5-3 (+SL) - IA5-4 (-SL) | Always | Below 1 Ω |
Disconnect the service wire from connector B.
| *1 | Front Airbag Sensor LH |
| *2 | Airbag Sensor Assembly |
| *3 | Engine Room Main Wire |
| *4 | Instrument Panel Wire |
| *5 | Service Wire |
| *a | Front view of wire harness connector (to Airbag Sensor Assembly) |
| *b | Front view of wire harness connector (to Engine Room Main Wire) |
|
| ||||
| OK | ||
| ||
| 8.CHECK INSTRUMENT PANEL WIRE (SHORT) |
![]() |
Disconnect the instrument panel wire connector from the engine room main wire.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| IA5-3 (+SL) - IA5-4 (-SL) | Always | 1 MΩ or higher |
| *1 | Front Airbag Sensor LH |
| *2 | Airbag Sensor Assembly |
| *3 | Engine Room Main Wire |
| *4 | Instrument Panel Wire |
| *a | Front view of wire harness connector (to Engine Room Main Wire) |
|
| ||||
| OK | ||
| ||
| 9.CHECK INSTRUMENT PANEL WIRE (SHORT TO B+) |
![]() |
Disconnect the instrument panel wire connector from the engine room main wire.
Connect the cable to the negative (-) battery terminal.
Turn the engine switch on (IG).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| IA5-3 (+SL) - Body ground | Engine switch on (IG) | Below 1 V |
| IA5-4 (-SL) - Body ground | Engine switch on (IG) | Below 1 V |
| *1 | Front Airbag Sensor LH |
| *2 | Airbag Sensor Assembly |
| *3 | Engine Room Main Wire |
| *4 | Instrument Panel Wire |
| *a | Front view of wire harness connector (to Engine Room Main Wire) |
|
| ||||
| OK | ||
| ||
| 10.CHECK INSTRUMENT PANEL WIRE (SHORT TO GROUND) |
![]() |
Disconnect the instrument panel wire connector from the engine room main wire.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| IA5-3 (+SL) - Body ground | Always | 1 MΩ or higher |
| IA5-4 (-SL) - Body ground | Always | 1 MΩ or higher |
| *1 | Front Airbag Sensor LH |
| *2 | Airbag Sensor Assembly |
| *3 | Engine Room Main Wire |
| *4 | Instrument Panel Wire |
| *a | Front view of wire harness connector (to Engine Room Main Wire) |
|
| ||||
| OK | ||
| ||