Home › Engine / Hybrid System ยท CRUISE CONTROL › CRUISE CONTROL SYSTEM

DTC    P050013    Vehicle Speed Sensor "A" Circuit Open

for Preparation Click here


DESCRIPTION

The cruise control system uses the same vehicle speed signal that is sent to the ECM for the SFI system. If DTC P050013 is detected, perform diagnosis using the inspection procedure for DTC P050013 in the SFI system. (Click here).
The detection conditions for DTC P050013 stored in the cruise control system are the same as for DTC P050031 stored in the SFI system.

DTC No.
DTC Detection Condition
Trouble Area
P050013
The vehicle speed signal from the vehicle speed sensor stops for 0.14 sec. or more while the cruise control system is controlling vehicle speed.
  1. Vehicle speed sensor
  2. Vehicle speed sensor signal circuit
  3. Combination meter assembly
  4. ECM

WIRING DIAGRAM

Refer to SFI System .

INSPECTION PROCEDURE

HINT:
This DTC may be output by the SFI system at the same time. In that case, perform troubleshooting for the SFI system first.

1.CHECK FOR DTCS (DTC P050013)
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Clear the DTCs (Click here).

  1. Perform the following to make sure that the DTC detection conditions are met.

    HINT:
    If the detection conditions are not met, the malfunction cannot be detected.

    1. With the shift lever in D, drive the vehicle for more than 10 seconds when the engine coolant temperature is more than 20°C (68°F).

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC is not output
    A
    DTC P050013 is output
    B



B
GO TO SFI SYSTEM (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)