DTC P057162 Brake Switch "A" Signal Compare Failure |
| DTC No. | DTC Detection Condition | Trouble Area |
| P057162 | When voltage of STP terminal and that of ST1- terminal of ECM are less than 1 V for 0.5 sec. or more |
|

| 1.CHECK HARNESS AND CONNECTOR (POWER SOURCE, BODY GROUND) |
![]() |
Disconnect the stop light switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A77-3 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A77-1 (B) - A77-3 (GND) | Always | 11 to 14 V |
| A77-5 (B) - A77-3 (GND) | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Stop Light Switch Assembly) |
Reconnect the stop light switch assembly connector.
|
| ||||
| OK | |
| 2.INSPECT STOP LIGHT SWITCH ASSEMBLY |
Inspect the stop light switch assembly (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (ECM - STOP LIGHT SWITCH ASSEMBLY) |
Disconnect the ECM connector.
Disconnect the stop light switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A84-9 (STP) - A77-2 (OUT) | Always | Below 1 Ω |
| A84-10 (ST1-) - A77-4 (L) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| A84-9 (STP) or A77-2 (OUT) - Body ground | Always | 10 kΩ or higher |
| A84-10 (ST1-) or A77-4 (L) - Body ground | Always | 10 kΩ or higher |
Reconnect the stop light switch assembly connector.
Reconnect the ECM connector.
|
| ||||
| OK | ||
| ||