Home › Engine / Hybrid System ยท CRUISE CONTROL › CRUISE CONTROL SYSTEM

DTC    P057504    Cruise Control System Internal Failure

DTC    P057549    Cruise Control Internal Electronic Failure

for Preparation Click here


DESCRIPTION

This DTC indicates an abnormality in the ECM.

DTC No.
DTC Detection Condition
Trouble Area
P057504
When the following conditions are met:
0.4 sec. have passed after cruise cancel input signal (STP input) is input to the ECM
ECM
P057549
When the following conditions are met:
0.4 sec. have passed after cruise cancel input signal (STP input) is input to the ECM
ECM

INSPECTION PROCEDURE

HINT:
The ECM receives signals from each sensor to control all functions of the cruise control system. When a trouble code is detected, the fail-safe function remains on until the ignition switch is turned off.

1.CHECK FOR DTCS (CRUISE CONTROL SYSTEM)
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Clear the DTCs (Click here).

  1. Perform the following to make sure that the DTC detection conditions are met.

    HINT:
    If the detection conditions are not met, the malfunction cannot be detected.

    1. Drive the vehicle at a speed for which cruise control system operation is possible.

    2. Turn the cruise control system on using the cruise control switch (ON-OFF button).

    3. Push the cruise control switch to -/SET to begin control of vehicle speed using the cruise control system.

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
REPLACE ECM (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)