CAN COMMUNICATION SYSTEM > Navigation ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Navigation ECU Communication Stop Mode | Either condition is met:
|
|

| 1.CHECK FOR OPEN IN CAN BUS LINES (NAVIGATION RECEIVER ASSEMBLY BRANCH LINE) |
Disconnect the cable from the negative (-) battery terminal.
![]() |
Disconnect the I67 navigation receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I67-9 (CANH) - I67-10 (CANL) | Cable disconnected from negative (-) battery terminal | 54 to 69 Ω |
| *a | Front view of wire harness connector (to Navigation Receiver Assembly) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |
Disconnect the I64 navigation receiver assembly connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I64-7 (GND1) - Body ground | Cable disconnected from negative (-) battery terminal | Below 1 Ω |
Connect the cable to the negative (-) battery terminal.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I64-3 (ACC1) - Body ground | Ignition switch ACC | 11 to 14 V |
| I64-4 (+B1) - Body ground | Ignition switch off | 11 to 14 V |
| I67-1 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Navigation Receiver Assembly) |
| Result | Proceed to |
| OK (for TMC, TMMR Made) | A |
| OK (for TMMK Made) | B |
| NG | C |
|
| ||||
|
| ||||
| A | ||
| ||