CAN COMMUNICATION SYSTEM > DCM Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| DCM Communication Stop Mode | Either condition is met:
|
|

| 1.CHECK FOR OPEN IN CAN BUS LINES (TELEMATICS TRANSCEIVER BRANCH LINE) |
Disconnect the cable from the negative (-) battery terminal.
![]() |
Disconnect the I218 telematics transceiver.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I218-15 (CANP) - I218-16 (CANN) | Cable disconnected from negative (-) battery terminal | 54 to 69 Ω |
| *a | Front view of wire harness connector (to Telematics Transceiver) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I218-4 (E) - Body ground | Cable disconnected from negative (-) battery terminal | Below 1 Ω |
| *a | Front view of wire harness connector (to Telematics Transceiver) |
Connect the cable to the negative (-) battery terminal.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I218-1 (+B) - Body ground | Ignition switch off | 11 to 14 V |
| I218-8 (ACC) - Body ground | Ignition switch ACC | 11 to 14 V |
| I218-7 (IG2) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Telematics Transceiver) |
|
| ||||
| OK | ||
| ||