Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION SYSTEM (for TMMK Made)

OCCUPANT CLASSIFICATION SYSTEM (for TMMK Made) > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Turn the engine switch off.

  2. Connect the GTS to the DLC3.

  3. Turn the engine switch on (IG).

  4. Turn the GTS on.

  5. Enter the following menus: Body Electrical / Occupant Detection / Data List.

  6. Read the Data List according to the display on the GTS.

    Occupant Detection 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    IG Switch
    Engine switch condition/
    ON: Engine switch on (IG)
    OFF: Engine switch off
    ON/OFF
    -
    Passenger Buckle SW
    Passenger side buckle switch/
    Set: Front passenger seat belt is fastened
    Unset: Front passenger seat belt is not fastened
    NG: Data is not determined
    Set/Unset
    -
    Passenger Classification
    Passenger classification/
    AM50: Adult is seated
    AF05: Adult is seated
    Child: Child is seated
    CRS: Child restraint system is installed
    OFF: Vacant
    AM50/AF05/Child/CRS/OFF
    -
    Sensor Range Info
    Sensor range information/
    OK: Always
    OK
    As sensor range is not set, OK is always displayed
    FL Sensor Range Info
    Front left sensor range information/
    OK: Always
    OK
    As front left sensor range is not set, OK is always displayed
    RL Sensor Range Info
    Rear left sensor range information/
    OK: Always
    OK
    As rear left sensor range is not set, OK is always displayed
    FL Sensor Voltage
    Front left sensor voltage/
    Min.: 0.000 V
    Max.: 19.800 V
    0.000 to 5.000 V
    -
    RL Sensor Voltage
    Rear left sensor voltage/
    Min.: 0.000 V
    Max.: 19.800 V
    0.000 to 5.000 V
    -
    FL Sensor Weight Info
    Front left sensor weight information/
    Min.: -10.00 kg (-22.05 lb)
    Max.: 20.00 kg (44.09 lb)
    -10.00 to 20.00 kg
    (-22.05 to 44.09 lb)
    -
    RL Sensor Weight Info
    Rear left sensor weight information/
    Min.: -10.00 kg (-22.05 lb)
    Max.: 30.00 kg (66.13 lb)
    -10.00 to 30.00 kg
    (-22.05 to 66.13 lb)
    -
    Total Weight Information
    Total weight information/
    Min.: -40.00 kg (-88.19 lb)
    Max.: 100.00 kg (220.46 lb)
    -40.00 to 100.00 kg
    (-88.19 to 220.46 lb)
    -
    Number of Present DTC
    Number of present DTC recorded/
    Min.: 0, Max.: 255
    0
    -
    Number of Past DTC
    Number of past DTC recorded/
    Min.: 0, Max.: 255
    0
    -