FRONT SEAT OUTER BELT ASSEMBLY > DISPOSAL |
| 1. DISPOSE OF FRONT SEAT OUTER BELT ASSEMBLY (WHEN INSTALLED IN VEHICLE) |
![]() |
Check the function of SST.
![]() |
Connect the red clip of SST to the battery positive (+) terminal and the black clip to the battery negative (-) terminal.
| *1 | Battery |
![]() |
Press the SST deployment switch and check that the LED of the SST deployment switch illuminates.
Disconnect the seat belt pretensioner connector.
Remove the center pillar lower garnish (Click here).
![]() |
Using a screwdriver, pull out the locking button in the direction shown by the arrow in the illustration to release the lock, and disconnect the pretensioner connector as shown in the illustration.
| *a | Protective Tape |
![]() |
Connect SST.
Connect 2 SST, and then connect them to the seat belt pretensioner.
![]() |
Move SST at least 10 m (33 ft.) away from the front of the vehicle.
| *a | 10 m or more |
Close all the doors and windows of the vehicle.
Deploy the seat belt pretensioner.
Confirm that no one is inside the vehicle or within a 10 m (33 ft.) radius of the vehicle.
Connect the red clip of SST to the battery positive (+) terminal and the black clip to the negative (-) terminal.
Press the SST deployment switch to deploy the seat belt pretensioner.
![]() |
Dispose of the seat belt.
Remove the seat belt and SST.
Place the seat belt in a plastic bag, tie the end tightly, and dispose of it in the same way as other general parts.
| 2. DISPOSE OF FRONT SEAT OUTER BELT ASSEMBLY (WHEN NOT INSTALLED IN VEHICLE) |
Remove the seat belt (Click here).
![]() |
Wind the seat belt webbing with the retractor.
| *a | Cut |
| *b | 100 mm |
When the seat belt webbing is sufficiently wound, cut the seat belt webbing approximately 100 mm (3.94 in.) from the retractor, as shown in the illustration.
![]() |
Check the function of SST.
![]() |
Connect the red clip of SST to the battery positive (+) terminal and the black clip to the battery negative (-) terminal.
| *a | Battery |
![]() |
Press the SST deployment switch and check that the LED of the SST deployment switch illuminates.
![]() |
Connect SST.
Connect 2 SST, and then connect them to the seat belt pretensioner.
![]() |
Place the seat belt on the ground and cover it with a tire and wheel assembly.
Position and hold SST at least 10 m (33 ft.) away from the wheel.
![]() |
Deploy the seat belt pretensioner.
| *a | 10 m or more |
Check that no one is within a 10 m (33 ft.) radius of the wheel.
Connect the red clip of SST to the battery positive (+) terminal and the black clip to the battery negative (-) terminal.
Press the SST deployment switch to deploy the seat belt pretensioner.
![]() |
Dispose of the seat belt.
Remove the wheel and SST.
Place the seat belt in a plastic bag, tie the end tightly, and dispose of it in the same way as other general parts.