Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR

FRONT STABILIZER BAR > REMOVAL

for Preparation Click here



1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
for 2AR-FE: (Click here)
for 2GR-FE: (Click here)
for 6AR-FSE: (Click here)


2. REMOVE FRONT STABILIZER LINK ASSEMBLY LH


  1. for Steel Type:



      C239297
    1. Remove the nut and front stabilizer link assembly LH from the front stabilizer bar.
      If the ball joint turns together with the nut, use a hexagon wrench to hold the stud bolt.



  1. for Aluminum Type:



      C238974
    1. Remove the nut and front stabilizer link assembly LH from the front stabilizer bar.
      If the ball joint turns together with the nut, use a wrench to hold the stud bolt.



3. REMOVE FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Perform the same procedure as the LH side.



4. REMOVE FRONT NO. 1 STABILIZER BRACKET LH


    C238973
  1. Remove the 2 bolts and front No. 1 stabilizer bracket LH from the front frame assembly.



5. REMOVE FRONT NO. 1 STABILIZER BRACKET RH

HINT:
Perform the same procedure as the LH side.



6. REMOVE FRONT STABILIZER BAR
  1. Remove the front stabilizer bar from the front frame assembly.



7. REMOVE FRONT NO. 1 STABILIZER BAR BUSHING
  1. Remove the 2 front No. 1 stabilizer bar bushings from the front stabilizer bar.