Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER (for TMC, TMMR Made)

REAR SHOCK ABSORBER (for TMC, TMMR Made) > DISPOSAL

for Preparation Click here



1. DISPOSE OF REAR SHOCK ABSORBER ASSEMBLY


    C132473E02
  1. Fully extend the shock absorber piston rod.

  1. Using a drill, make a hole in the cylinder between A and B as shown in the illustration to discharge the gas inside.

    CAUTION:
    Be careful when drilling as shards of metal may fly about, so always use proper safety equipment.

    HINT:
    The gas is colorless, odorless and non-poisonous.