Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER (for TMMK Made)

REAR SHOCK ABSORBER (for TMMK Made) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.



1. REMOVE REAR SIDE SEATBACK ASSEMBLY
(Click here)


2. REMOVE REAR WHEEL


3. SEPARATE REAR STABILIZER LINK ASSEMBLY


    C239069
  1. Remove the nut and separate the rear stabilizer link assembly from the rear shock absorber assembly.
    If the ball joint turns together with the nut, use a hexagon wrench to hold the stud.



4. SEPARATE SKID CONTROL SENSOR WIRE


    C132461
  1. Remove the 2 bolts, and disconnect the rear flexible hose and skid control sensor wire from the rear shock absorber assembly.



5. REMOVE REAR NO. 1 SUSPENSION SUPPORT COVER


    C132462
  1. Using a screwdriver, disengage the 4 claws and remove the rear No. 1 suspension support cover.



6. REMOVE REAR SHOCK ABSORBER WITH COIL SPRING


    C239068E01
  1. Support the rear axle carrier sub-assembly with a jack using a wooden block.
    Text in Illustration 
    *1
    Jack
    *2
    Wooden Block

    HINT:
    Support the rear axle carrier sub-assembly until reinstallation of the rear shock absorber with coil spring is complete.



    C132463
  1. Loosen the rear support to rear shock absorber nut of the rear shock absorber assembly.

    NOTICE:
    1. Do not remove the rear support to rear shock absorber nut.
    2. Loosen the nut only when the rear shock absorber with coil spring needs to be disassembled.



    C132464
  1. Remove the 2 bolts and 2 nuts, and separate the rear shock absorber with coil spring from the rear axle carrier sub-assembly.

    NOTICE:
    When removing the nuts, keep the bolts from rotating.



    C132465
  1. Remove the 3 nuts and rear shock absorber with coil spring.

    NOTICE:
    Make sure that the skid control sensor wire and rear flexible hose are disconnected from the rear shock absorber with coil spring.



7. REMOVE REAR SUPPORT TO REAR SHOCK ABSORBER NUT


    C265186E01
  1. Secure SST in a vise.

    SST
    09727-30021   (09727-00010, 09727-00021, 09727-00031)



    C263591
  1. Attach the arm of SST to the diameter of the rear coil spring.

    CAUTION:
    1. Make sure that the rear coil spring is installed so that the distance between the upper and lower hooks of SST is at the maximum.
    2. Make sure that the claws of the hooks are securely attached.

  1. Using SST, compress the rear coil spring.

    CAUTION:
    1. If the rear coil spring bends during the compression, immediately stop the compression and reinstall SST.
    2. Do not compress the spring until the coil springs contact each other.
    3. Do not use an impact wrench. It will damage SST.

  1. Confirm that the rear coil spring becomes free and remove the rear support to rear shock absorber nut.

    CAUTION:
    Do not remove the rear support to rear shock absorber nut when the rear coil spring is not free.



8. REMOVE REAR SUPPORT TO REAR SHOCK ABSORBER COLLAR


9. REMOVE REAR SUSPENSION SUPPORT ASSEMBLY


10. REMOVE REAR COIL SPRING


11. REMOVE REAR NO. 1 SPRING BUMPER


12. REMOVE REAR LOWER COIL SPRING INSULATOR


13. REMOVE REAR SHOCK ABSORBER ASSEMBLY