Home › Suspension › REAR SUSPENSION › REAR STRUT ROD (for TMC, TMMR Made)

REAR STRUT ROD (for TMC, TMMR Made) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.



1. REMOVE REAR WHEEL


2. REMOVE NO. 2 FLOOR UNDER COVER (for LH Side)


  1. for TMC Made:



      C310499
    1. Remove the screw and 2 clips.
      Text in Illustration 
      V100135
      Nut (attached to under cover)
      V100136
      Screw

    2. Disengage the 6 nuts and remove the No. 2 floor under cover.

      HINT:
      The 6 nuts will remain attached to the No. 2 floor under cover.



  1. for TMMR Made:



      C309401
    1. Remove the 2 clips.
      Text in Illustration 
      V100135
      Nut (attached to under cover)

    2. Disengage the 6 nuts and remove the No. 2 floor under cover.

      HINT:
      The 6 nuts will remain attached to the No. 2 floor under cover.



3. REMOVE NO. 1 FLOOR UNDER COVER (for RH Side)


  1. for TMC Made:



      C310498
    1. Remove the screw.
      Text in Illustration 
      V100135
      Nut (attached to under cover)
      V100136
      Screw

    2. Disengage the 5 nuts and 2 clips, and remove the No. 1 floor under cover.

      HINT:
      Rotate the clips to disengage them. The 5 nuts and 2 clips will remain attached to the No. 1 floor under cover.



  1. for TMMR Made:



      C309402
    1. Disengage the 5 nuts and 2 clips, and remove the No. 1 floor under cover.
      Text in Illustration 
      V100135
      Nut (attached to under cover)

      HINT:
      Rotate the clips to disengage them. The 5 nuts and 2 clips will remain attached to the No. 1 floor under cover.



4. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY


    C240545
  1. Remove the bolt and separate the No. 3 parking brake cable assembly from the vehicle.



5. REMOVE REAR STRUT ROD ASSEMBLY


    C241287E01
  1. Support the rear axle carrier sub-assembly with a jack using a wooden block.
    Text in Illustration 
    *1
    Jack
    *2
    Wooden Block



    C132475
  1. Remove the bolt, nut and separate the rear strut rod assembly (front side).

    NOTICE:
    When removing the bolt, keep the nut from rotating.



    C132476
  1. Remove the bolt, nut and rear strut rod assembly from the rear axle carrier sub-assembly.

    NOTICE:
    When removing the bolt, keep the nut from rotating.