Home › Suspension › REAR SUSPENSION › REAR STRUT ROD (for TMMK Made)

REAR STRUT ROD (for TMMK Made) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.



1. REMOVE REAR WHEEL


2. REMOVE NO. 2 FLOOR UNDER COVER (for LH Side)


    C308787
  1. Remove the 2 bolts, screw and 2 clips.
    Text in Illustration 
    V100135
    Bolt
    V100136
    Screw
    V100137
    Nut (attached to under cover)

  1. Disengage the 3 nuts and remove the No. 2 floor under cover.



3. REMOVE NO. 1 FLOOR UNDER COVER (for RH Side)


    C308788
  1. Remove the 2 bolts and screw.
    Text in Illustration 
    V100135
    Bolt
    V100136
    Screw
    V100137
    Nut (attached to under cover)

  1. Disengage the 3 nuts and 2 clips, and remove the No. 1 floor under cover.



4. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY


    C239078
  1. Remove the bolt and separate the No. 3 parking brake cable assembly from the vehicle.



5. REMOVE REAR STRUT ROD ASSEMBLY


    C239068E01
  1. Support the rear axle carrier sub-assembly with a jack using a wooden block.
    Text in Illustration 
    *1
    Jack
    *2
    Wooden Block



    C239079
  1. Remove the 2 bolts and separate the rear strut rod assembly (front side).



    C239631
  1. Remove the bolt, nut and rear strut rod assembly from the rear axle carrier sub-assembly.

    NOTICE:
    When removing the bolt, keep the nut from rotating.