Home › Suspension › REAR SUSPENSION › REAR LOWER ARM (for TMMK Made)

REAR LOWER ARM (for TMMK Made) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.
  3. The rear No. 2 suspension arm assembly can be removed directly from the vehicle.



1. REMOVE REAR WHEELS


2. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (for RH Side)
(Click here)


3. SEPARATE REAR NO. 2 SUSPENSION ARM ASSEMBLY


    C239073
  1. Remove the bolt, nut and separate the rear No. 2 suspension arm assembly (outer side) from the rear axle carrier sub-assembly.

    NOTICE:
    When removing the bolt, keep the nut from rotating.



4. REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY


    C239075
  1. Remove the bolt and rear No. 2 suspension arm assembly from the rear suspension member sub-assembly.



5. REMOVE REAR SUSPENSION MEMBER SUB-ASSEMBLY
(Click here)


6. REMOVE REAR NO. 1 SUSPENSION ARM ASSEMBLY


    C239076
  1. Remove the bolt and rear No. 1 suspension arm assembly from the rear suspension member sub-assembly.