AUTOMATIC HIGH BEAM SYSTEM > OPERATION CHECK |
| AUTOMATIC HIGH BEAM SYSTEM OPERATION CHECK |
![]() |
Check the operation of the automatic high beam indicator light.
Turn the ignition switch to ON.
Turn the light control switch to the AUTO position.
Cover the automatic light control sensor to turn the low beam headlights on.
Move the dimmer switch to the high position.
Check that the automatic high beam indicator comes on.
| *a | Automatic High Beam Indicator Light |
Check the operation of the automatic high beam function.
At night, when driving the vehicle with the automatic high beam system in standby mode, check that the high beams automatically turn on after a short delay when all of the following conditions are met:
At night, when driving the vehicle with the high beams turned on by the automatic high beam system, check that the automatic high beam system turns off the high beams and returns to standby mode when any of the following conditions are met: