LIGHTING SYSTEM > ACC Signal Circuit |

| 1.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
Read the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| ACC SW | Ignition switch ACC signal/ON or OFF | ON: Ignition switch ACC OFF: Ignition switch off | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - BATTERY AND BODY GROUND) |
Disconnect the 3F*1, 3E*2 and 3B instrument panel junction block assembly connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3F-1 - Body ground*1 | Ignition switch off | 11 to 14 V |
| 3E-1 - Body ground*2 | Ignition switch off | 11 to 14 V |
| 3B-23 - Body ground | Ignition switch ACC | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3B-7 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (ACC NO. 1 RELAY) |
Remove the instrument panel junction block assembly (Click here).
Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.
Measure the resistance according to the value(s) in the table below.

| *a | Component without harness connected (Instrument panel junction block assembly) | *b | for RHD |
| *c | for LHD | - | - |
| Tester Connection | Condition | Specified Condition |
| 3F-1 - MB-29 (ACC)*1 | Always | 10 kΩ or higher |
| 3F-1 - MB-29 (ACC)*1 | Battery positive (+) → 3B-23 Battery negative (-) → 3B-7 | Below 1 Ω |
| 3E-1 - MB-29 (ACC)*2 | Always | 10 kΩ or higher |
| 3E-1 - MB-29 (ACC)*2 | Battery positive (+) → 3B-23 Battery negative (-) → 3B-7 | Below 1 Ω |
|
| ||||
| OK | ||
| ||