DTC B2416 Height Control Sensor Malfunction |
| DTC No. | DTC Detecting Condition | Trouble Area |
| B2416 |
|
|

| 1.CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 2.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / AFS / Data List.
Read the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Height Sens Pw Supply Val | Height control sensor power supply value / 0.00 to 6.25 V | Approx. 5.0 V | - |
|
| ||||
| OK | ||
| ||
| 3.INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY |
Remove the rear height control sensor sub-assembly (Click here).
Inspect the rear height control sensor sub-assembly (Click here).
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) - REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY) |
Disconnect the A35 AFS ECU (headlight swivel ECU assembly) connector.
Disconnect the O17 rear height control sensor sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A35-18 (SBR) - O17-3 (SHB) | Always | Below 1 Ω |
| A35-19 (SHRL) - O17-2 (SHRR) | Always | Below 1 Ω |
| A35-21 (SGR) - O17-1 (SHG) | Always | Below 1 Ω |
| A35-18 (SBR) - Body ground | Always | 10 kΩ or higher |
| A35-19 (SHRL) - Body ground | Always | 10 kΩ or higher |
| A35-21 (SGR) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||