Home › Vehicle Exterior › LIGHTING (EXT) › AFS (ADAPTIVE FRONT-LIGHTING SYSTEM)

AFS (ADAPTIVE FRONT-LIGHTING SYSTEM) > AFS ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit detects the state of the ignition switch, and sends it to the AFS ECU (headlight swivel ECU assembly).

WIRING DIAGRAM


E168165E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (BATTERY - AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY))


    E166980E42
  1. Disconnect the A35 AFS ECU (headlight swivel ECU assembly) connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A35-14 (IGS) - Body ground
    Ignition switch ON
    11 to 14 V
    Ignition switch off
    Below 1 V
    A35-15 (IG) - Body ground
    Ignition switch ON
    11 to 14 V
    Ignition switch off
    Below 1 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to AFS ECU (Headlight Swivel ECU Assembly))



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) - BODY GROUND)
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A35-22 (E1) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)