POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on Front Door Windows) > INITIALIZATION |
| INITIALIZE POWER WINDOW CONTROL SYSTEM (FRONT DOORS) |
Perform initialization according to the table below.
| Condition of Power Window | Proceed to |
| Initialization method when a power window regulator motor assembly (for driver door) or power window regulator motor assembly (for front passenger door) has been replaced with a new one. | Procedure A |
| Procedure B |
| Initialization method for when the door glass unexpectedly operates in reverse or stops due to a change in the sliding resistance after a fitting adjustment is made. | Procedure C |
Procedure A
Perform registration of the door glass position (fully closed, fully open) and sliding resistance learning.

Procedure B
Reset the door glass position, and perform registration of the door glass position (fully closed, fully open) and sliding resistance learning.


Procedure C
Perform sliding resistance learning.
