SEAT HEATER SWITCH (for TMC, TMMR Made Front Side) > INSPECTION |
| 1. INSPECT SEAT HEATER SWITCH (for LH) |
Check the seat heater switch.
![]() |
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected (Seat Heater Switch (for LH)) |
| Tester Connection | Switch Condition | Specified Condition |
| 8 - 6 | OFF | 10 kΩ or higher |
| 8 - 6 | ON | 350 Ω to 3.4 kΩ |
| 8 - 3 | ON | Below 1 Ω |
Check that the LED illuminates.
![]() |
Apply battery voltage to the seat heater switch (for LH) and check that the LED illuminates.
| *a | Component without harness connected (Seat Heater Switch (for LH)) |
| Measurement Condition | Switch Condition | Specified Condition |
| Battery positive (+) → Terminal 7 Battery negative (-) → Terminal 2 | - | LED illuminates |
| Battery positive (+) → Terminal 8 Battery negative (-) → Terminal 4 | ON |
| 2. INSPECT SEAT HEATER SWITCH (for RH) |
Check the seat heater switch.
![]() |
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected (Seat Heater Switch (for RH)) |
| Tester Connection | Switch Condition | Specified Condition |
| 7 - 5 | OFF | 10 kΩ or higher |
| 7 - 5 | ON | 350 Ω to 3.4 kΩ |
| 7 - 2 | ON | Below 1 Ω |
Check that the LED illuminates.
![]() |
Apply battery voltage to the seat heater switch (for RH) and check that the LED illuminates.
| *a | Component without harness connected (Seat Heater Switch (for RH)) |
| Measurement Condition | Switch Condition | Specified Condition |
| Battery positive (+) → Terminal 6 Battery negative (-) → Terminal 1 | - | LED illuminates |
| Battery positive (+) → Terminal 7 Battery negative (-) → Terminal 3 | ON |